A practical reference on RP-HPLC: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-10-06 and is reviewed periodically as new material appears.
The compound was developed at Novo Nordisk during the 1990s as part of a programme seeking secretagogues with improved selectivity. It was described in the peer-reviewed literature in 1998 alongside related pentapeptides from the same series. Investigators advanced it because it raised growth hormone output in animal models while leaving other pituitary hormones comparatively unaffected. The development code NNC 26-0161 appears in earlier reports, and ipamorelin later became the common designation in published work.
Selectivity is the property most often attached to this peptide. Published animal and early human studies record increases in growth hormone release after administration, with adrenocorticotropic hormone and cortisol responses remaining small by comparison. Effects on appetite-related pathways also appear weaker than those reported for several earlier secretagogues. Reviews that compare members of the growth hormone secretagogue family cite these findings frequently, though the receptor-level explanation for the selectivity continues to be debated rather than settled.
Ipamorelin is a synthetic pentapeptide classified as a growth hormone secretagogue. Its sequence, Aib-His-D-2-Nal-D-Phe-Lys-NH2, combines three non-proteinogenic residues with a C-terminal amide. The N-terminal aminoisobutyric acid unit and the two aromatic D-amino acids distinguish it from peptides assembled only from standard L-amino acids. Its formula is C38H49N9O5, corresponding to an average mass near 711.9 Da. At neutral pH the molecule carries a net positive charge, a property that shapes its behaviour in chromatographic and electrophoretic systems.
Material supplied for research use is normally a white to off-white lyophilized powder. The solid is hygroscopic and is handled in a low-humidity environment to limit water uptake. Bulk quantities are frequently shipped in sealed vials under inert gas. Once reconstituted in water or a neutral buffer, the solution is less stable than the dry powder and is usually divided into single-use aliquots.
Long-term storage of the dry powder is typically at minus twenty degrees Celsius or lower, protected from light and moisture. Solutions are commonly kept frozen and thawed only once, because repeated freeze-thaw cycles can promote aggregation and loss of measurable peptide content. Buffers near neutral pH are preferred over strongly acidic or strongly basic conditions. Shipping at ambient temperature is acceptable for short periods when the powder remains sealed and desiccated.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H49N9O5 | Pentapeptide with C-terminal amide |
| Average mass | Approximately 711.9 Da | Value derived from the formula |
| Appearance | White to off-white powder | Typically supplied as a lyophilised solid |
| Solubility | Soluble in water and aqueous acetonitrile | Dissolution aided by acidic diluents |
| Common synonyms | Ipamorelin; NNC 26-0161 | Code name used in early reports |
Mass spectrometry confirms identity and reveals structural deviations that chromatography alone can miss. Positive-mode electrospray ionisation generally yields multiply charged ions whose deconvoluted mass is checked against the theoretical value. Amino acid analysis, and enzymatic digestion with subsequent fragment mapping, provide independent confirmation of sequence and of the terminal amide. Analysts take care to separate the target from deletion sequences, which may differ by one residue and therefore by only a small mass increment.
The lyophilised solid is normally held at -20 °C or colder, shielded from light and moisture. Stability in that state is measured in years, although shelf life depends on residual water content and the container seal. Once dissolved, the peptide is more fragile: aqueous solutions are commonly kept at 2-8 °C and used within days to weeks, and repeated freeze-thaw cycling is avoided. Strongly acidic or basic conditions accelerate hydrolysis, and prolonged exposure to them can strip the terminal amide.
Purity assessment for this peptide relies mainly on reversed-phase high-performance liquid chromatography. A C18 column with a water-acetonitrile gradient containing trifluoroacetic acid separates the target from truncated sequences and oxidation products. Detection near 214 nm exploits the amide backbone, while the aromatic side chains allow additional monitoring close to 280 nm. Reported purity values depend on the method, so a certificate of analysis carries weight only when gradient, column and integration parameters are given.
Compared with earlier growth hormone secretagogues such as GHRP-6 and hexarelin, ipamorelin has been reported to produce less stimulation of adrenocorticotropic hormone, cortisol, and prolactin in animal and early human studies. This selectivity is usually attributed to differences in receptor subtype interactions and to the tissue distribution of the receptor. Effects on appetite appear weaker than those of ghrelin itself, although the supporting evidence base is small. Whether these differences produce a distinct clinical profile remains an open question, since controlled human trials are limited.
Ipamorelin is a synthetic pentapeptide first described in the 1990s by researchers at Novo Nordisk during a program to develop selective growth hormone secretagogues. Its sequence is Aib-His-D-2-Nal-D-Phe-Lys-NH2, incorporating two non-natural residues, alpha-aminoisobutyric acid and D-2-naphthylalanine. The C-terminus is amidated, and the material is supplied as a white lyophilized powder. The molecular formula is C38H49N9O5 and the monoisotopic mass is approximately 711.85 daltons. The short chain and modified residues give it greater resistance to enzymatic degradation than many larger peptide hormones.
At the molecular level, ipamorelin acts as an agonist at the growth hormone secretagogue receptor type 1a, the same G protein-coupled receptor that binds ghrelin. Receptor activation couples to Gq/11 signaling, raising intracellular calcium through inositol trisphosphate and diacylglycerol, which in turn promotes exocytosis of growth hormone from pituitary somatotroph cells. Ipamorelin binds this receptor with high affinity and shows weak activity at other secretagogue-related targets in vitro. Its action requires the intact receptor and is not reversed by growth hormone-releasing hormone antagonists.
One distinguishing feature reported in animal studies is selectivity. Ipamorelin stimulated growth hormone release with limited elevation of adrenocorticotropic hormone or cortisol compared with earlier secretagogues such as GHRP-6. This pattern has been described as more selective for the growth hormone axis. The finding comes mainly from preclinical work, and the degree to which it holds across species and doses is not fully settled. Reports also describe effects on gastric motility in animal models, suggesting activity outside the pituitary, though the clinical relevance of this observation is uncertain.
Ipamorelin is a synthetic pentapeptide that acts on the growth hormone secretagogue receptor, also known as the ghrelin receptor. Its sequence contains five amino acid residues, including a non-natural residue that increases stability against enzymatic breakdown. The compound was developed in the 1990s as part of research into small peptides that stimulate pituitary hormone release. Unlike larger protein hormones, it can be produced by solid-phase peptide synthesis and characterized by standard analytical methods.
Lyophilized ipamorelin is generally held at minus twenty degrees Celsius or colder, protected from light and moisture. In solution the peptide is less stable, and degradation proceeds through hydrolysis of the amide backbone, oxidation of the histidine residue, and aggregation. Repeated freeze-thaw cycles accelerate these processes, so dividing material into single-use aliquots before freezing is common practice in research settings. Buffered formulations near neutral pH tend to show the slowest degradation, while strongly acidic or basic conditions raise hydrolysis rates. Stability data specific to ipamorelin are sparse, and much guidance is extrapolated from other short peptides.
Quality control for research-grade ipamorelin is not governed by a single harmonized pharmacopeial monograph, so certificates of analysis vary between suppliers. Common tests include appearance, solubility, water content, peptide content by quantitative amino acid analysis, and residual counterion measurement. Independent verification by an outside laboratory is often used to confirm identity and purity claims. Salt form, counterion content, and residual solvent levels are frequently unspecified, which complicates direct comparison between lots and leaves reproducibility partly unresolved.
Identity and purity assessment of ipamorelin relies mainly on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometers, a wavelength where the peptide backbone absorbs. Mass confirmation is typically obtained by electrospray ionization mass spectrometry or by liquid chromatography coupled to mass spectrometry, comparing the observed mass with the calculated value. Amino acid analysis and peptide mapping after enzymatic digestion can confirm the sequence. Impurity profiles include deletion peptides, truncated fragments, and oxidation products, reported as relative area percentages.
== External links == "Melanocortin Receptors: MC2". IUPHAR Database of Receptors and Ion Channels. International Union of Basic and Clinical Pharmacology. Archived from the original on 2016-03-03. Retrieved 2007-07-23. MC2+Receptor at the U.S. National Library of Medicine Medical Subject Headings (MeSH) Human MC2R genome location and MC2R gene details page in the UCSC Genome Browser.
Prometheus may create a problem in that, in accordance with the ruling in that case, "it may be said that such and such genes manufacture this protein in the same way they always did in a mammal, they produce the same product, and the genetic modification technology used is conventional, so that the steps of the process 'add nothing to the laws of nature that is not already present. If the argument prevailed in court, the process would also be ineligible for patent protection. This issue has not yet been decided in the courts.
=== Plastics === Calcium carbonate is commonly used in the plastic industry as a filler. When it is incorporated in a plastic material, it can improve the hardness, stiffness, dimensional stability and processability of the material.
Sources: en.wikipedia.org
== Medication compliance == Medication compliance is defined as the degree to which the patient follows the therapy that is recommended by healthcare professionals. There are direct and indirect methods to evaluate compliance. Direct method refers to the measurement that the healthcare professionals observed or measure the patient's drug-taking behavior. Indirect method refers to the healthcare professionals do not observe or measure the drug-taking behavior of the patient but use the other source of information to evaluate the compliance. The direct method includes measurement of drug (or the corresponding metabolite) concentration, while the indirect method includes pill counting and the self-report from the patient. The direct method is more time-consuming, more expensive, more invasive, but it is more accurate. The indirect method has a lower accuracy but is easier to administer to the patient. If the patient fails to comply with treatment, for example, by not taking the medication according to the instructions, it leads to risk and a poor treatment outcome.
Prohibitin-targeting peptide 1 (also known as prohibitin-TP01 and TP01; trade name Adipotide) is a peptidomimetic with sequence CKGGRAKDC-GG-D(KLAKLAK)2. It is an experimental proapoptotic drug that has been shown to cause rapid weight loss in mice and rhesus monkeys. Its mechanism of action is to target specific blood vessels supplying adipose tissue with blood, cause the vessels to shrink and the fat cells fed by those vessels to undergo apoptosis. TP01 is designed to bind to two receptors, ANXA2 and prohibitin, that are specific to blood vessels supplying white adipose tissue. As of 2019, clinical development has been discontinued.
Carcinoma: Cancers derived from epithelial cells. This group includes many of the most common cancers that occur in older adults. Nearly all cancers developing in the breast, prostate, lung, pancreas, and colon are carcinomas. Sarcoma: Cancers arising from connective tissue (i.e. bone, cartilage, fat, nerve), each of which develop from cells originating in mesenchymal cells outside of the bone marrow. Lymphoma and leukemia: These two classes of cancer arise from immature cells that originate in the bone marrow, and are intended to fully differentiate and mature into normal components of the immune system and the blood, respectively. Acute lymphoblastic leukemia is the most common type of cancer in children, accounting for ~30% of cases. However, far more adults than children develop lymphoma and leukemia. Germ cell tumor: Cancers derived from pluripotent cells, most often presenting in the testicle or the ovary (seminoma and dysgerminoma, respectively). Blastoma: Cancers derived from immature "precursor" cells or embryonic tissue. Blastomas are generally more common in children (e.g. neuroblastoma, retinoblastoma, nephroblastoma, hepatoblastoma, medulloblastoma, etc.) than in older adults.
== Pharmacology == Lorazepam has anxiolytic, sedative, hypnotic, amnesic, anticonvulsant, and muscle relaxant properties. It is a high-potency and an intermediate-acting (10–20 hour half-life) benzodiazepine, and its uniqueness, advantages, and disadvantages are largely explained by its pharmacokinetic properties (poor water and lipid solubility, high protein binding and anoxidative metabolism to a pharmacologically inactive glucuronide form) and by its high relative potency (lorazepam 1 mg is equal in effect to diazepam 10 mg). The biological half-life of lorazepam is 10–20 hours.
Sources: en.wikipedia.org
It is a synthetic five-amino-acid peptide that acts as a growth hormone secretagogue. Three of its residues are non-standard amino acids, and the chain ends in an amide rather than a free acid. The molecule is small enough that it can be characterised by routine peptide analytical techniques.
It has not received marketing approval as a medicine in the United States or the European Union. Supplied material is generally described and handled as a research chemical. Regulatory treatment varies by jurisdiction, and some countries restrict growth hormone secretagogues under sports or medicines legislation.
Earlier secretagogues were associated with broader hormonal responses, including measurable changes in cortisol and prolactin. Reports on this peptide describe a narrower profile in which growth hormone release is the most prominent effect. The observation is influential because it shapes how the compound is compared with other members of the same receptor family.
Dry powder is held at minus twenty degrees Celsius or colder, away from light and moisture. Sealed vials under inert gas limit degradation during storage.